Instructions for Wood Sign Kits

Carefully remove pieces from the package. Some pieces are small, so you want to make sure you do not lose anything.
Start by painting the base piece of wood (sign back). You can also stain this part of the sign.
Paint each piece the desired colors you have chosen. You will probably need two coats of paint if you like full coverage. You can wipe any excess paint off with baby wipes or a damp paper towel.
Once the pieces are dry, you can glue them to the sign. I recommend using clear Gorilla Glue & using a small amount on each piece. Gently press down to secure it to the base of the sign.
Allow to glue to set for at least 30 minutes. You might need to adjust some of the pieces a little bit before the glue is actually dry.

Instructions for Pop Out Ornament Kits

Carefully remove the pop out card from the package. Some of the pieces may have popped off of the wood card and you do not want to lose them.
Gently pop each piece off of the wood card. Use an Exacto knife if anything seems difficult to pop out of the card.
Paint each piece the desired colors you have chosen. You will probably need two coats of paint if you like full coverage. You can wipe any excess paint off with baby wipes or a damp paper towel.
Once the pieces are dry, you can glue them to the sign. I recommend using clear Gorilla Glue & using a small amount on each piece. Gently press down to secure it to the base of the sign.
Allow to glue to set for at least 30 minutes. You might need to adjust some of the pieces a little bit before the glue is actually dry.
Add the ribbon and bead to the opening on the top of the ornament and tie off the ribbon.